Table of Contents
The Evolution of the Solar Charge Controller
December 3, 2016
A charge controller is a piece of equipment designed to prevent the batteries in your system from overcharging. It is similar to the voltage regulator in a car. However, unlike a voltage regulator in an automobile, charge controllers have advanced in ways never even imaginable to the hippies in Northern California, USA in the 1970s… […]
comments
Read the full article →
The MPPT Charge Controller | How it has Changed Everything!
July 23, 2016
The maximum power point tracking… MPPT charge controller … has got to be one of the most innovative, game changing and misunderstood components in the solar industry. There is so much misinformation, it is time to clear up the myths of the MPPT charge controllers, explain what they do and explore what they cannot do. […]
comments
Read the full article →
How To Make Your Batteries Last as Long as Possible
September 12, 2015
Your battery bank will likely be one if the most expensive components of your “off the grid” energy system. They are also the only piece of the system that will need replacing on a regular basis. Every extra day you can squeeze out of your battery bank will reduce the overall cost of your renewable […]
comments
Read the full article →
Dump Loads for Solar, Wind and Microhydro
May 2, 2013
Dump loads a.k.a. diversion loads are are an important part of the off grid electric system. Almost all wind and water turbine installations will require them and most solar installations can benefit from a dump load. As we discussed in the dump load intro, a dump load is simply an electrical device (load) to send […]
comments
Read the full article →
Skystream Automatic Disconnection
April 22, 2013
Southwest Windpower’s Skystream can be used to charge batteries but a circuit must be present that will shut the turbine down as the batteries reach a full state of charge or a circuit to dump the extra power. If you could hire someone inexpensively to shut the breaker off as the batteries “top off” that […]
comments
Read the full article →
Skystream Battery Charging How To
April 18, 2013
The Skystream made by Southwest Windpower is a grid tie wind turbine that is designed to produce 240 volts AC at 60HZ (or 50HZ) no matter what speed the wind is blowing. It does this by taking the wild AC from the alternator, rectifying it to DC and inverting back to AC. It is quite […]
comments
Read the full article →
Dump Load / Diversion Load Intro
April 16, 2013
Since there is a lot of confusion about diversion loads, we will discuss what they are and why they are used. A dump load is nothing more than a resistor (heating element) that is used for dumping electricity when it is not needed or to prevent your battery bank from being overcharged. It could be […]
comments
Read the full article →
Using an Electric Heater as a Dump Load
April 12, 2013
A common question I get asked is “Can I use a standard 120/240 AC heating element or hot water heater element as a DC dump load for my wind turbine/water turbine/solar system?” (Wondering what a dump load is? Click here) (More advanced diversion load info for solar, wind and water power) The answer is yes […]
comments
Read the full article →